Canadian Airgun Forum

Oh, goodness. I posted a photo of my new 22 piledriver beside a Superpoint on the Crosman forum. Now I'm getting Emails......."where can I get some to play with???"

Sooooooo..........I just advise them that I'm the only source in North America and they are 35.00US for 100.........orders are ROLLING in.

KIDDING.

It seems that the 'group' is interested in something new to shoot

Again - thanks Randy - apparently your hard work has made our little forum the envy of the WORLD!!!!!

RIGHT ON

Cheers - Gus

_________________
"Political Correctness is a doctrine fostered by a delusional,
illogical, liberal minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."

I shot off a few in the 2240 project of mine. Surprisingly, better than I thought it would have been. They're sure tough to load, they need a little push to get in there, compared to a regular pellet just happily going in. http://airgunfight.blogspot.com/

_________________
Slavia 631 tuned w/ AB3 spring - Slavia 631 tuned w/ stock spring - Crosman 2240 w/ RJM breech, 2289 barrel & stock

Just did some penetration tests (I know ) on a project......cutting a 20" springer to 10". I used Superpoints and the penetration was identical with both barrel lengths. All measured 1/2" in the piece of pine I was using. And yes, the shots were fairly close in order to reduce the effects of differing density in the same piece of wood.

Then I shot some Piledrivers into the same area......and got 3/4" penetration. Unfortunately, the wood belonged to a stud in the wall in my basement.......couldn't take it out to split the wood and determine what actually happened INSIDE the wood to the pellets.

So......further tests will have to wait until it's warm enough to set up in my garage again

Hopefully someone else will have done this before spring

Cheers - Gus

_________________
"Political Correctness is a doctrine fostered by a delusional,
illogical, liberal minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."

wow .... sounds good Gus, I just got mine today, thanks to Randy ...

BUT the damn Condor is not here yet .... damn it .....

got mine today as well!
almost hard to tell which end goes where!

Thanks everyone for all the support. I have another shipment on the way dare I say somemore advanced designs but i need to be patient and wait for them too. If ther is enough interest I maybe working with a good friend of mine to start supplying north America in large quantities but time will tell as my next move will be controlled by member product reviews. I hope to use them in my Condor sometime this weekend. Thanks again.

Randy

http://www.airgunforum.net/agf/index.ph ... llets&st=0

820.2
765.8

41yd
123ft

Uprange Chrono Distance = 2 ft
Uprange Projectile Velocity = 820.2 ft/s
Downrange Chrono Distance = 123 ft
Downrange Projectile Velocity = 765.8 ft/s

Calculated Ballistic Coefficient:
~0.0735
(~0.073)

_________________
Slavia 631 tuned w/ AB3 spring - Slavia 631 tuned w/ stock spring - Crosman 2240 w/ RJM breech, 2289 barrel & stock