HI Jay....
I checked out the website, and I see you are starting to supply the Disco / 22XX market as well.... I was wondering if you will be making a riser breech with magazine for those.... and will the magazine be your own, or accept the Marauder magazine?....
I like the magazine for the riser breech because the pellet is fully contained.... which I assume means that it can be cycled without having to "hold the gun level" as with the RIM magazines ?....
I was also wondering if you have ever considered building a tank mounting block for the Disco / 22XX similar to the QB79 block but designed to withstand HPA safely.... the QB79 blocks have been known to blow off the end of the tube by shearing the bolts in HPA use.... because they are only located with two 4mm screws of questionable quality.... A properly designed tank mounting block could actually fit all the 22XX / Disco / QB's out there and would provide a nice addition to your line up.... I have been prototyping this type of setup in the following thread:
http://www.airgunforum.ca/forums/viewtopic.php?f=14&t=27470If you were making the tank mounting block from scratch, it would be a simple matter to make the mounting holes further from the end, and set them up like the Disco valve.... three 8-32 pan head screws screwed flush to the valve with the heads in shear in 5/16" holes in the tube, one in each side and one in the top (leaving the bottom for the air port).... and then two O-ring grooves behind that for sealing.... Alternately, you could make a one-piece assembly like the last version I have done in that thread, with an integral guage mount.... two mounting screws and the guage stem in shear....
If I can be of any assistance, feel free to PM me.... I have a bit of CNC experience (no programming) and I'm pretty good at brainstorming this type of stuff.... Not after any compensation, I'd just like to see a great product on the market, both for myself and others....
Bob