I use a spring compressor like this, completely contains the gun, which becomes more of a issues with magnum springers...Been using this specific one since I made the video over 4years ago
http://www.youtube.com/watch?v=RkaEldsPwks
| Canadian Airgun Forum https://www.airgunforum.ca/forums/ |
|
| GOHAR 177 break barrel - ever heard of it? https://www.airgunforum.ca/forums/topic57148-15.html |
Page 2 of 2 |
| Author: | jgoodz420 [ Sat Aug 31, 2013 2:45 pm ] |
| Post subject: | Re: GOHAR 177 break barrel - ever heard of it? |
I use a spring compressor like this, completely contains the gun, which becomes more of a issues with magnum springers...Been using this specific one since I made the video over 4years ago http://www.youtube.com/watch?v=RkaEldsPwks
|
|
| Author: | Plinkercases [ Sat Aug 31, 2013 4:06 pm ] |
| Post subject: | Re: GOHAR 177 break barrel - ever heard of it? |
Nice rig up thanks. I always find the comments on youtube as entertaining as the videos! I may try a combo of your rig and the bar clamp I have that Docgadget says he uses. I have space at the farm shop so that helps...and it has steel walls so not like to get penetrated by a fly away!...it would be me I am worried about. Plinker |
|
| Author: | Plinkercases [ Mon Sep 02, 2013 3:01 pm ] |
| Post subject: | Re: GOHAR 177 break barrel - ever heard of it? |
Well I did a test. Firing into a tight layer cardboard as follows; 20 feet same pellet in each PX4 storm (advertised at 380 fps) new cannister new Px4 - 5 shots penetrating 5th layer 45 yr+ Relum (perhaps?) - 3 shots to 5th layer 2 shots to 6th layer Old springer wins! I think i will leave off messing with springs for now and work on a new stock and scope and clean up the steel a a little. To be honest I was suprised but pelase with the results. Plinker |
|
| Author: | joe hickey [ Mon Sep 02, 2013 8:07 pm ] |
| Post subject: | Re: GOHAR 177 break barrel - ever heard of it? |
If it is indeed a leather seal then a drop or two of oil through the transfer port on top of the piston, couldn,t hurt. That is if you haven't already done that. I had one leather seal gun a few years back that was pretty dry, and it was suggested I put a lot of oil in there then stand upright over night, then drain with the barrel broke open for a few hour,s. It will likely diesel for a while but you will certainly get maximum power. |
|
| Author: | Plinkercases [ Mon Sep 02, 2013 8:41 pm ] |
| Post subject: | Re: GOHAR 177 break barrel - ever heard of it? |
I will try that. Pelgun or if a lot how about 3 in 1 or something else? |
|
| Page 2 of 2 | All times are UTC - 5 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|