Canadian Airgun Forum

The #1 Community for Airguns in Canada!
It is currently Tue Oct 26, 2021 1:19 pm

All times are UTC - 5 hours


The Canadian Airgun Forums are a place for people to discuss and learn about airguns and the airgunning sport in Canada. There are lots of discussions about airguns, airgun accessories, reviews, modification and repair information, airgun events, field target and free classifieds!

 

You need to register before you can post: click the register link to proceed. Before you register, please read the forum rules. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload your own pictures, and access many other special features. Registration is fast, simple, and absolutely free! To start viewing messages, select the forum that you want to visit from the selection below.






Post new topic Reply to topic  [ 17 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: Thu Sep 16, 2021 8:59 am 
Offline
User avatar

Joined: Thu Sep 02, 2021 12:52 pm
Posts: 22
Location: Hamilton, ON
Isn't that last little cut bit unnecessary?
The way you have it oriented, it's only providing about 1mm of added length to the rod as the rod reaches in and touches the bottom of the cut/empty cartridge is it not?


Perhaps that little bit is needed to make it work, but I'm suspicious if it's necessary.
When you say finger tight to the last thread, do you mean fully closing the cap entirely, or does it the cap still sit out a bit from the tube when tightened with carts inside as per norm?

Also I believe Bob's advice to cut the cart in two places so it sits between 2nd/3rd carts would be 'safer' in the long-term.
By positioning your 2nd/3rd carts directly neck to neck, there's a chance it could put too much pressure and bend/damage the necks slightly - though it may be unlikely.

_________________
Worse things have happened to better people.

"A mind all logic is like a knife all blade, it makes the hand bleed that uses it."


Top
 Profile  
 
PostPosted: Thu Sep 16, 2021 12:43 pm 
Offline

Joined: Tue Nov 18, 2014 12:23 pm
Posts: 226
Location: Calgary
The cap was threaded down all the way finger tight, no treads left. It might work without the spacer, I'll likely try that next. I don't think the cap ends pressed together will be an issue. They are flat and the thin puncture section is not taking the load, it goes right into the strong casing material.

_________________
Slavia 630/77
Slavia 624
1322
1377
2240
2240/2260 20"
WF600
Vantage .22
Vantage .22 (.177 if the barrel shows up)
Walther Falcon Hunter .22
Walther Talon Magnum .25


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 17 posts ]  Go to page Previous  1, 2

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
News News Site map Site map SitemapIndex SitemapIndex RSS Feed RSS Feed Channel list Channel list

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

phpBB SEO