Canadian Airgun Forum
https://www.airgunforum.ca/forums/

Filling in the front breech pita screw hole on a 22xx?
https://www.airgunforum.ca/forums/topic77368.html
Page 1 of 1

Author:  Canadianguy [ Wed Oct 04, 2017 3:51 pm ]
Post subject:  Filling in the front breech pita screw hole on a 22xx?

I'm just looking for some ideas on filling that front breech pita screw hole, where the pellet gets caught up. Someone mentioned using clear 5 min epoxy.

Any suggestions would be appreciated!

Thanks

Author:  airmec [ Wed Oct 04, 2017 4:04 pm ]
Post subject:  Re: Filling in the front breech pita screw hole on a 22xx?

Candle wax. Easy to remove if you have to, but strong enough to stay put :wink:

Author:  MyCrosman [ Wed Oct 04, 2017 4:12 pm ]
Post subject:  Re: Filling in the front breech pita screw hole on a 22xx?

.....or that stuff called "Goop"....turns into a hard rubber but you can pull it off easy with needle nose or whatever if you need to......you can form it too after it settles a bit....

Author:  Canadianguy [ Wed Oct 04, 2017 4:16 pm ]
Post subject:  Re: Filling in the front breech pita screw hole on a 22xx?

That's intresting to...I actually have some auto goop!

Author:  Gippeto [ Wed Oct 04, 2017 9:08 pm ]
Post subject:  Re: Filling in the front breech pita screw hole on a 22xx?

airmec wrote:
Candle wax. Easy to remove if you have to, but strong enough to stay put :wink:


X2

Author:  Canadianguy [ Tue Nov 21, 2017 12:59 pm ]
Post subject:  Re: Filling in the front breech pita screw hole on a 22xx?

If I don't take the reciever off,will any of the wax fall down the pita screw hole into the tube?

Will wax leave any wax residue into the barrel?

I guess I could put a piece of tape at the bottom of the hole.

I figured it out!

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/