Canadian Airgun Forum
https://www.airgunforum.ca/forums/

Using a original 1322 barrel on 2240
https://www.airgunforum.ca/forums/topic77505.html
Page 1 of 1

Author:  YepYep [ Tue Oct 17, 2017 2:24 pm ]
Post subject:  Using a original 1322 barrel on 2240

Hello friends ~

I added one 2240 to my collection. And as I replaced the original 1322 barrel with a 14inch barrel, I got the 10inch 1322 barrel aside and I want to put it onto the 2240 to replace its original 7inch barrel.

Any suggestions and things I need to watch out ?

From the EVP and PL chart, the tip of the two barrels are a little bit different, but I will use a muzzle brake with sight pin to replace the front sight, so it should not cause any trouble right ?

Thanks for your input in advance!! [emoji8]

Sent from my LG mobile

Author:  wllm995 [ Tue Oct 17, 2017 2:25 pm ]
Post subject:  Re: Using a original 1322 barrel on 2240

Should be NO problem at all!

Did it myself with no issues.

:)

Author:  leadslinger [ Tue Oct 17, 2017 2:27 pm ]
Post subject:  Re: Using a original 1322 barrel on 2240

Only difference is that the 1322 10.1" doesn't have a flat section for the factory sight to stay leveled ( chance of it spinning around on the barrel ) But if your using a aftermarket muzzle brake it wouldn't be a issue.

Author:  YepYep [ Tue Oct 17, 2017 3:03 pm ]
Post subject:  Re: Using a original 1322 barrel on 2240

Nice to get the confirmations with the old birds ~ [emoji16]

I will finish it later after the stock and muzzle brake from D&L arrive.

At the time I will also put a high flow transfer port with cover-all seal which bought from UK from ebay previously. Although I don't think I can tell the difference between this to the other high flow port from alliance-hobby which is on my 1322 currently, it's nice to try something new~

Re-using the 1322 barrel save me a lot in here ~ [emoji16]

Sent from my LG mobile

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/