Canadian Airgun Forum
https://www.airgunforum.ca/forums/

Crosman Premier HPs
https://www.airgunforum.ca/forums/topic77645.html
Page 1 of 1

Author:  TCooper [ Sun Nov 05, 2017 10:29 am ]
Post subject:  Crosman Premier HPs

I had a bit of free time this week so I quickly measured out the head size on a tin of CPHP pellets. The results were better than anticipated. I tossed out a couple that were .174".

.180" - 2 pellets
.179" - 17 pellets
.178" - second highest count
.177" - highest count by far
.176" - third highest count
.175" - 15 pellets

Attachments:
PelletSorting 003c.jpg
PelletSorting 003c.jpg [ 302.71 KiB | Viewed 434 times ]

Author:  Nod [ Sun Nov 05, 2017 10:59 am ]
Post subject:  Re: Crosman Premier HPs

Probably the best cheap pellets around. All of my guns liked them.

Author:  Basement Shooter [ Wed Nov 08, 2017 4:28 am ]
Post subject:  Re: Crosman Premier HPs

Hey. Guys
Yes I think Crosman have the best pellets. There is very expensive pellets out there which is fine but Crosman (made in USA ,look for that) is consistent in size and you can count on that .Economically, reasonably accurate if using same pellets .Consistentency is what your after.
I have 4x 500 tins of Tamahawk? Pellets. They fold in my hand as I put them in without any resistance.
I thought Benjamin (I have two of their awesome guns) would have put out better ammo with their name but they are the same. Three tins of 500 which are garbage.
I use: Crosman Premier destroyer, hollow point, and pointed. Looked at Cabelas and couldn't find wad cutters. I found them there before.
I have many CO2 guns. Pistols and MP40 legends (takes 2 cylinders). Crosman cylinders are are better than Daiseys.(they seal better)
Umarex Steel or Hornandy BB's are the best BB's.
Cheers
Copperhead are crap. I tried to load a few BB guns with Copperhead and they were inconsistent. Rolling out. Bought the proper Umarex BB's ,problem solved

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/