I built this from parts I had here and some disco parts and a 2240 I had ordered online to try and shoot .25 pellets from some experimental barrels I had been working on. It is pretty plain other than the home made barrel and front sight, and rear mim sight. the tube is a cut off /modded 2260, and it shoots benjamin 27 gr. pellets just below 500fps . I was hopefull to hit the broad side of a barn with the home built barrel. I let a friend shoot 10 shots at the target in the pic (4 1/4 inch target?) from exactly 30 ft., just leaning off a table in his garage, didn't do too bad at all, and would like to try more distance... maybe it could get tighter with more rounds down the pipe and a bench rest. It's had approx. 150 pellets through it, So far I'm fairly pleased, and will keep on tryin.
Cheers-Matt
| Attachments: |
|
IMG_0921.png [ 377.73 KiB | Viewed 1801 times ] |
|
IMG_0919.jpg [ 473.6 KiB | Viewed 1801 times ] |
|
IMG_4771.jpg [ 97.57 KiB | Viewed 1801 times ] |
1-20 in. left twist as I can measure. this one spits out the .25 27 gr. at 340fps with a 6 inch pipe, AND I can hit cans from 20 feet and send them flying just for fun. I can waste a few big pellets, then I can swap the 22 barrel back into it in 2 minutes. This sends .22 14 gr. CHP at 440ish fps. with approx. the same length barrel, it's just good clean cheap fun!
