Canadian Airgun Forum
https://www.airgunforum.ca/forums/

Hammer Stop in a Regulated PCP ?
https://www.airgunforum.ca/forums/topic55882-15.html
Page 2 of 2

Author:  Voltar1 [ Fri Jul 05, 2013 5:21 pm ]
Post subject:  Re: Hammer Stop in a Regulated PCP ?

Jon wrote:
3mm square its the thickest point.

Your not bending laterally or diagonally so don't matter.
So if your right a Purdey main spring at 285 thou wide will be stronger than a 220 thou wide spring. The strength is from the turn approx. 125 thou and the flat arms much thinner as they taper down.


Say whot?

I have no clue what you are saying.

Page 2 of 2 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/