Canadian Airgun Forum https://www.airgunforum.ca/forums/ |
|
2240 vs 1377 hammer pin https://www.airgunforum.ca/forums/topic71882.html |
Page 1 of 1 |
Author: | RobertMcC [ Sun Mar 27, 2016 4:39 pm ] |
Post subject: | 2240 vs 1377 hammer pin |
Can someone measure their 2240 hammer pin? I'm using a 1377 hammer pin with a 2240 maintube and hammer. I think it's dragging. The trigger pull is heavier than before. I know the 1377 hammer and maintube is smaller dia. Thanks Robert |
Author: | badshot [ Mon Mar 28, 2016 6:03 pm ] |
Post subject: | Re: 2240 vs 1377 hammer pin |
Crosman lists the same part# for the 2240 and 1377 hammer pin |
Author: | rsterne [ Mon Mar 28, 2016 6:17 pm ] |
Post subject: | Re: 2240 vs 1377 hammer pin |
Yep, they are identical.... My guess is you have a burr in the cocking slot, or maybe the sear slot, that the hammer or pin is catching on.... Bob |
Author: | DerekVinyard [ Mon Mar 28, 2016 7:19 pm ] |
Post subject: | Re: 2240 vs 1377 hammer pin |
Back off the breech screw, the #8-32 on the back and make sure it's not rubbing. Happens with custom breeches or replaced screws. |
Author: | RobertMcC [ Tue Mar 29, 2016 8:03 am ] |
Post subject: | Re: 2240 vs 1377 hammer pin |
DerekVinyard wrote: Back off the breech screw, the #8-32 on the back and make sure it's not rubbing. Happens with custom breeches or replaced screws. Thanks, I'll check that out. I'm going to polish up the hammer. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |