Canadian Airgun Forum
https://www.airgunforum.ca/forums/

Latest custom BAM parts.
https://www.airgunforum.ca/forums/topic74669.html
Page 1 of 1

Author:  SaskAirgunKid96 [ Thu Dec 08, 2016 1:45 am ]
Post subject:  Latest custom BAM parts.

So let's start with a big thanks to Daryl.
Now onto the meat of things. I opened a few boxes today and found my Regulator, .22 FX Smooth Twist Barrel, and a new hammer spring.
The gun was amazing as it was when I got it, but I'm not one to leave well enough alone. I'm hoping to squeeze just a tad more accuracy and move my hunting range from 30 out to 50 yards. I'm also hoping to make my 100 yards target shooting a bit more consistent. I know I'm dealing with air but I feel like a 20 inch group could be improved. Both through my shooting and the gun. The best 100 yard group was shot by a friend of mine and was about a foot across still.

Author:  Daryl [ Thu Dec 08, 2016 1:50 pm ]
Post subject:  Re: Latest custom BAM parts.

Have you tried the 19.09gr. H&N Barracuda HP pellets - or Predators? IIRC, the rifle liked the H&H's. They are slower but hit hard and are fairly consistent in accuracy.

Author:  SaskAirgunKid96 [ Fri Dec 09, 2016 10:03 pm ]
Post subject:  Re: Latest custom BAM parts.

I've been fiddling with the Crosman Penetrators, JSB Monsters, Crosman Premier HP and Dome. I just ordered some Predators, JSB Exact, and H&N Baracuda Match Heavies. I'm also still waiting on one of those Nomad Pellet Makers. The barrel in the BAM now is quite nice still and I think I'll put that barrel into a Carbine I'm working on. I just love the look and feel of the BAM so I think the Smooth Twist should be a nice fit, I also hoping with the Regulator I could do some impressive shooting.

Author:  Daryl [ Sat Dec 10, 2016 3:16 pm ]
Post subject:  Re: Latest custom BAM parts.

Hope so, too. Good luck!

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/