Canadian Airgun Forum
https://www.airgunforum.ca/forums/

Brocock concept question
https://www.airgunforum.ca/forums/topic75776.html
Page 1 of 1

Author:  balan [ Fri Mar 24, 2017 12:11 pm ]
Post subject:  Brocock concept question

Need to put new barrel band on a Brocock Concept. Has anyone disassembled the plug holding inlet valve and barrel band on one of these guns? I'm assuming the two flanges that the band fits between are screwed together but if so they're very tight. Putting a scratch on this thing is not an option so if anyone has disassembled one of these would be nice to hear about it.

Ron

Author:  balan [ Fri Mar 24, 2017 7:28 pm ]
Post subject:  Re: Brocock concept question

Well, after contemplating my dilemma for a while I threw together a smaller version of a wrench my partner uses to separate barrels from recievers. Worked like a charm. Brocock end plug is totally dismantled and no scratch's.

Ron

Author:  Daryl [ Fri Mar 24, 2017 7:57 pm ]
Post subject:  Re: Brocock concept question

Glad it worked for you.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/