Canadian Airgun Forum
https://www.airgunforum.ca/forums/

PP700sa barrel removal instructions part 1
https://www.airgunforum.ca/forums/topic82079.html
Page 1 of 1

Author:  Hobbyman2007 [ Sun Feb 17, 2019 9:04 am ]
Post subject:  PP700sa barrel removal instructions part 1

A few pics and instructions on how to remove / replace barrel on the PP700SA. Good for those who want to do a caliber swap or rework their existing barrel .
1- degas the gun , you can either shoot it down to a low enough pressure that you can overcome the poppet by pressing on the hammer or use the tool that came with the pistol and loosen the Guage slowly unscrewing until the air comes out .
2-remove the barrel tensioning nut , I use a pair of snap ring pliers then remove the shroud
Attachment:
3AD9793C-F8AA-4E5B-85DE-B41B711BC4A7.jpeg
3AD9793C-F8AA-4E5B-85DE-B41B711BC4A7.jpeg [ 49.23 KiB | Viewed 703 times ]

3-remove the hammer spring tensioning nut and hammer spring
Attachment:
B8E002D6-4D30-4C9A-A2BB-AFCC45212C2D.jpeg
B8E002D6-4D30-4C9A-A2BB-AFCC45212C2D.jpeg [ 64.99 KiB | Viewed 703 times ]

4-remove the pin holding the hammer and remove hammer
Attachment:
71DDAFB5-5B57-46E2-A74D-AED3B8D679D3.jpeg
71DDAFB5-5B57-46E2-A74D-AED3B8D679D3.jpeg [ 107.57 KiB | Viewed 703 times ]


More on part 2

Author:  leadslinger [ Sat Mar 16, 2019 4:16 pm ]
Post subject:  Re: PP700sa barrel removal instructions part 1

Like to add something, that I didn't see in the walk through. I had trouble removing the barrel tension nut. Took more force then it should have. I noticed on the barrel tension nut that, there was lines on it.

There is a small set screw under the front sight. That you need to loosen in order to take the barrel tension nut off. Meaning you need to take the front sight off, to gain access to it.

Also I also noticed that. 2 of the 4 screws that hold the grip part on, kinda acts as anti walk pin stop for the hammer pin. Or at least it was on mine.

Author:  Hobbyman2007 [ Sun Mar 17, 2019 6:09 pm ]
Post subject:  Re: PP700sa barrel removal instructions part 1

There’s something new . I just checked and neither of the pistols I have have a set screw under the front sight . Just goes to show one can never be too cautious when disassembling stuff. Never force something that should easily be removed . Good info and thanks for sharing Leadslinger .

Author:  wesb2007 [ Sun Mar 17, 2019 11:16 pm ]
Post subject:  Re: PP700sa barrel removal instructions part 1

Yes thanks! I thought these new ones were extra hard to remove. That's why I guess!

Sent from my EML-L09 using Tapatalk

Author:  leadslinger [ Mon Mar 18, 2019 8:58 am ]
Post subject:  Re: PP700sa barrel removal instructions part 1

Image

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/