Canadian Airgun Forum
https://www.airgunforum.ca/forums/

LR700W Mod by Pistolero
https://www.airgunforum.ca/forums/topic83439.html
Page 1 of 1

Author:  wesb2007 [ Sat Aug 10, 2019 7:03 pm ]
Post subject:  LR700W Mod by Pistolero

Hi Guys! Here's a cool mod made by Pistolero on his 3d printer. A replacement piece for the end cap on the LR700W that keeps the barrel nice and stable. Fits nice and snug with just enough room for the front sight. A great job!
Thanks to Pistolero for letting me try it out!
Regards,
Wes ImageImage

Sent from my EML-L09 using Tapatalk

Author:  Doc Sharptail [ Sun Aug 11, 2019 1:21 am ]
Post subject:  Re: LR700W Mod by Pistolero

Is this .22, or .177?

Interesting, especially if it closes up groups.

Personally, I think the .177 bbls are stiff enough that no extra reinforcement should be required.

The .22 may whip a bit, but I'm hard pressed to see it on groups shot at 20 yds..

-D.S.

Author:  wesb2007 [ Sun Aug 11, 2019 9:29 am ]
Post subject:  Re: LR700W Mod by Pistolero

This one is a 22 cal. I'll have to test it for groups with it on and off.
Regards,
Wes

Sent from my EML-L09 using Tapatalk

Author:  walther [ Sun Aug 11, 2019 1:41 pm ]
Post subject:  Re: LR700W Mod by Pistolero

Doc Sharptail wrote:
Is this .22, or .177?

Interesting, especially if it closes up groups.

Personally, I think the .177 bbls are stiff enough that no extra reinforcement should be required.

The .22 may whip a bit, but I'm hard pressed to see it on groups shot at 20 yds..

-D.S.


I have sourced a 3k carbon tube that fits perfectly over these barrels.
I have been wondering if one was bonded to a barrel how much if /any difference it would make on groups
(.22) due to added stiffness and barrel harmonics?
I just need another barrel band to remachine to 14mm to fit the sleeve.
(in case I muck it up)

Author:  wesb2007 [ Sun Aug 11, 2019 2:09 pm ]
Post subject:  Re: LR700W Mod by Pistolero

Very cool =)
Looking forward to your results. I've got spare barrel bands.
Regards,
Wes

Sent from my EML-L09 using Tapatalk

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/