Nice! That wouldn't have been me on the phone. I was settled up in less than 5 minutes!

Any idea on how much stock they have? Sure wish they had a brick and mortar out here to check out.

Here it is! Just opened it last night. Even in synthetic, she's a beauty. I really like the feel of the stock, and the air cylinder covering which seems to be some sort of carbon fiber. It's just insanely light too at 5.75 lbs.

One big problem: It didn't arrive with any air in it. I tried filling it, and it has a slow leak. Going to pull off the stock sometime soon and investigate, doesn't seem to be coming from the breech through the barrel, but from a connection from the air cylinder to the breech block.

Oh well, I called AGS, and Travis told me to pop off the stock and have a look. If it's easy, I'll fix it. If it's going to be tough, I'll send it back in. A little disappointing, but I knew this was a risk. I have no time to shoot it until the 18th anyhow.

Going to mount my Optisan Mamba on it, and find something else for the Hammerli. I do have a Bushnell Elite 4200 4-12x40 sitting around, but it doesn't have mil-dots.

Here it is! Just opened it last night. Even in synthetic, she's a beauty. I really like the feel of the stock, and the air cylinder covering which seems to be some sort of carbon fiber. It's just insanely light too at 5.75 lbs.

One big problem: It didn't arrive with any air in it. I tried filling it, and it has a slow leak. Going to pull off the stock sometime soon and investigate, doesn't seem to be coming from the breech through the barrel, but from a connection from the air cylinder to the breech block.

Oh well, I called AGS, and Travis told me to pop off the stock and have a look. If it's easy, I'll fix it. If it's going to be tough, I'll send it back in. A little disappointing, but I knew this was a risk. I have no time to shoot it until the 18th anyhow.

Going to mount my Optisan Mamba on it, and find something else for the Hammerli. I do have a Bushnell Elite 4200 4-12x40 sitting around, but it doesn't have mil-dots.

Yup, I tried that right off the bat. I started filling it and heard a pretty big hissing noise, so I tried cocking it and nothing. Let out a blast of noisy air, and still nothing. Once the pressure increased, the hissing stopped as far as I could tell. However, after if emptied the first time, I kept an eye on the gauge after filling again, and watched it drop very slowly until it hit a point where the very audible hissing started all the way down to empty. I figure it must be a seal that isn't catching properly, and needs re-seating or some silicone grease.

Seems like the stock is easily removable, so I will have a better look sometime soon. I'm not too worried about it, though. We'll get it figured out.

It definitely will look better with the shroud. I'll definitely post some results when I get this thing shooting!