| Canadian Airgun Forum https://www.airgunforum.ca/forums/ |
|
| Artemis CR600 CO2 .22 sight issue https://www.airgunforum.ca/forums/topic93757.html |
Page 1 of 1 |
| Author: | 80Indy [ Wed May 24, 2023 11:38 am ] |
| Post subject: | Artemis CR600 CO2 .22 sight issue |
I bought my first CO2 rifle. I have springers and multi pumps. I kind of like it. It'd a bit smaller and lighter than I thought it would be. It does around 535 fps. The only issue I have is with the rear sight, very little adjustment left of right. The sight has maybe 5 notches on each side of center but you can barely move it past one. Has anyone noticed this? |
|
| Author: | Knappr [ Wed May 24, 2023 12:22 pm ] |
| Post subject: | Re: Artemis CR600 CO2 .22 sight issue |
Just wondering if you have a second barrel band installed? If so loosen it and slight roll it in the direction that starts making a difference. I’ve had the same issue Also adjusting the sight requires you to loosen the left or right side of the windage adjuster before tighten in the direct you want to go. Ex need to move sight to the right, loosen left side first then tight the right side, then make sure both are tight after the adjustment is complete |
|
| Author: | wesb2007 [ Sat May 27, 2023 11:20 am ] |
| Post subject: | Re: Artemis CR600 CO2 .22 sight issue |
Yep loosening the side you want it to move towards is key. Otherwise you won't have any adjustment available to speak of, as mentioned above. Sent from my SM-A536W using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|