Do All Outdoor Pellet Trap

View unanswered posts | View active topics

Board index » Main Forum » Airgun Target

All times are UTC - 5 hours

The Canadian Airgun Forums are a place for people to discuss and learn about airguns and the airgunning sport in Canada. There are lots of discussions about airguns, airgun accessories, reviews, modification and repair information, airgun events, field target and free classifieds!

You need to register before you can post: click the register link to proceed. Before you register, please read the forum rules. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload your own pictures, and access many other special features. Registration is fast, simple, and absolutely free! To start viewing messages, select the forum that you want to visit from the selection below.

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

leadslinger

Post subject: Do All Outdoor Pellet Trap

Posted: Mon Nov 19, 2018 7:07 pm

Joined: Mon Aug 08, 2016 7:23 am
Posts: 4259
Location: Somewheres near the Atlantic

I wanted spinners for the basement. The 22 rimfire trap and spoons were sending alot back. So I seen this Do All Outdoor Pellet trap. 20 ish and free shipping over 35$ on Amazon. Figure I try it.

Comes flat box. With manual, screws, some assembly required. 2 targets, 2 replacement stickers, a warranty card.

Says rated for 800 FPS @ min 10M, and 1100 at 30M. .177 only. Holds a 7x9" target. It's your typical screw together, sheet metal type trap. It's just over 1mm thick. So I would we safe to say sub 500 FPS ONLY. Any distance less then 10M.

https://scontent.fyaw1-1.fna.fbcdn.net/ ... e=5C6799A2

Now Ive been using a thicker 2mm Remington trap in the basement. Upto 20 FPE. With a inch layer of duct seal.

So tomorrow I'll test it with some pellets from my P17 to see how dented it gets at 25ft.

Top

leadslinger

Post subject: Re: Do All Outdoor Pellet Trap

Posted: Tue Nov 20, 2018 12:54 pm

Joined: Mon Aug 08, 2016 7:23 am
Posts: 4259
Location: Somewheres near the Atlantic

Well I had a chance to play with it. I used Daisy wadcutters and RWS super points. Using my Beeman P17 ( 370 ish FPS ) Distance 25ft. Left no feel able dents on the back side. Like all metal traps. Safety glasses a must.

Could do with a thin layer of duct seal to control ricochets. I had a few pellets bounce out.

And I recorded a video. Even hitting the spinners they bounced out. I'm sure if you use BB's, they would ricochet more. So I wouldn't really recommend this trap for that. But not bad for 20$.

Top

Page 1 of 1

[ 2 posts ]

Board index » Main Forum » Airgun Target

All times are UTC - 5 hours

Who is online

Users browsing this forum: No registered users and 4 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum