Canadian Airgun Forum
https://www.airgunforum.ca/forums/

Easy holder for pop can shooters ~
https://www.airgunforum.ca/forums/topic83483-15.html
Page 2 of 2

Author:  Doc Sharptail [ Sat Aug 24, 2019 12:21 am ]
Post subject:  Re: Easy holder for pop can shooters ~

Here's how to shoot soda cans~ no holder required :wink:

Image

35 yds. It took 2 shots to connect with the pull ring tab rivet, due to wind. Poly-mag Predator Short 8.02 gr. Front rest only. Artemis PCP rifle with 3-9X 40mm A/O scope at 9X :mrgreen:

Yes, the can moved after the first shot, and I had to squirm around a little over the rest to make the second shot...

-D.S.

Author:  YepYep [ Sat Aug 24, 2019 7:44 am ]
Post subject:  Re: Easy holder for pop can shooters ~

[emoji38] great shot and great can holder ~ it looks I need to plant a tree in my backyard without delay, so that 30 years later, I can have a nice holder like yours after cut down the tree.... If I can still pick up the axe and shoot a gun that time ~

Talking about pull rings, actually I have been intended to aim and shoot through the pull ring on the can for a very long time, and finally successed recently for a lucky shot with my black eagle ~ that proved piling up the quantity will bring you success at last ~ [emoji38]


ImageImage

Sent from my S8 via Tapatalk

Author:  thumper [ Sat Nov 02, 2019 5:51 pm ]
Post subject:  Re: Easy holder for pop can shooters ~

...put a small hole near the edge of a TIN can,.....run some fish line through it ....secure a suitable length of the fish line so the can slides away from the shooter....the can will move along the line with each impact.......Double up to compete (race) with another shooter, being sure to give them the lesser powered pellet gun .....bet for beers.......( you can slow the pace down by raising the far end of the fish line ) ....

Page 2 of 2 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/