Canadian Airgun Forum https://www.airgunforum.ca/forums/ |
|
custom body tube for disco https://www.airgunforum.ca/forums/topic67067.html |
Page 1 of 1 |
Author: | OuttAmmo [ Fri Mar 13, 2015 1:54 pm ] |
Post subject: | custom body tube for disco |
im look for someone to make a main body tube for a project im building.. 22xx setup. if anyone can do this please pm me.. thanks J |
Author: | rrdstarr [ Fri Mar 13, 2015 6:31 pm ] |
Post subject: | Re: custom body tube for disco |
Contact Derek Vineyard. He made a batch last fall. |
Author: | OuttAmmo [ Fri Mar 13, 2015 8:36 pm ] |
Post subject: | Re: custom body tube for disco |
thanks.. I wasn't sure if he was still making them... J |
Author: | Doc Sharptail [ Mon Mar 16, 2015 11:41 am ] |
Post subject: | Re: custom body tube for disco |
There sure hasn't been a lot of discussion on this. Anyone completed a build yet? I know there was a bit of a list of interested people... Regards, Doc Sharptail |
Author: | OuttAmmo [ Wed Mar 18, 2015 5:28 pm ] |
Post subject: | Re: custom body tube for disco |
I pm'd derek no reply yet.. if not a custom tube.. can anybody cut down and rethread a disco tube? |
Author: | matt [ Wed Mar 18, 2015 7:20 pm ] |
Post subject: | Re: custom body tube for disco |
Not to recommend but..what I do is to cut the disco tube down from the back to shorten and then machine the holes and slots back in where I want em, as long as you take your time to be accurate things will fit back together. Drillpress with cross slide vise, and a dremel rotary tool. I have had no issues, but I dont run quite to max recommended psi either, remember safety first! |
Author: | rrdstarr [ Sat Mar 21, 2015 12:42 pm ] |
Post subject: | Re: custom body tube for disco |
matt wrote: Not to recommend but..what I do is to cut the disco tube down from the back to shorten and then machine the holes and slots back in where I want em, as long as you take your time to be accurate things will fit back together. Drillpress with cross slide vise, and a dremel rotary tool. I have had no issues, but I dont run quite to max recommended psi either, remember safety first! That would be the way I would do it also. But then again I bought a 1"-2" thread micrometer this week so I would want to try it out! |
Author: | OuttAmmo [ Mon Mar 23, 2015 1:51 pm ] |
Post subject: | Re: custom body tube for disco |
hey rrstarr would you be intrested in cutting and rethreading a disco tube for me? if so pm me.. thanks Jay |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |