Canadian Airgun Forum

The #1 Community for Airguns in Canada!
It is currently Sun Nov 17, 2019 5:15 am

All times are UTC - 5 hours


The Canadian Airgun Forums are a place for people to discuss and learn about airguns and the airgunning sport in Canada. There are lots of discussions about airguns, airgun accessories, reviews, modification and repair information, airgun events, field target and free classifieds!

 

You need to register before you can post: click the register link to proceed. Before you register, please read the forum rules. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload your own pictures, and access many other special features. Registration is fast, simple, and absolutely free! To start viewing messages, select the forum that you want to visit from the selection below.








Post new topic Reply to topic  [ 17 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: Wed Feb 19, 2014 3:19 pm 
Offline
User avatar

Joined: Mon Feb 11, 2013 12:46 am
Posts: 4121
joe hickey wrote:
Sorry Ace. I noticed it too late.

No prob buddy, It's all good, just thought I'd bring it to your attention :wink:

_________________
"A candle loses nothing by lighting another candle"

Image


Top
 Profile  
 
PostPosted: Wed Feb 19, 2014 3:49 pm 
Offline

Joined: Mon Jun 24, 2013 6:54 pm
Posts: 361
Location: Earth
joe hickey wrote:
Just cock the gun and it should seal OK. Same with bulk fill adapter,s.


The 2240 half cock should provide relief to even light valve springs and allow sealing for pressurization.
A related issue I have seen is that of manufacturing tolerances not allowing sufficient hipac to seal pressure to allow for greater charge pressures.
That is, valve/cart seal face is too far away from fully threaded hipac sealing surface when bottomed into the tube that it will leak when reaching 1500+ (in my case). The only remedy is to disassemble and shave the end of the tube down a few thou to allow hipac further depth to seal.

I have taken mine to 3k without issue, seal failure or leaks. Delrin poppet however as the stock seal can and will fail after prolonged use above 1600psi - detailed in a thread here somewhere.

I dream of the day someone makes and markets a peek poppet WITH a piercing pin to have the best of both worlds (tune notwithstanding).


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 17 posts ]  Go to page Previous  1, 2

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
News News Site map Site map SitemapIndex SitemapIndex RSS Feed RSS Feed Channel list Channel list

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

phpBB SEO