muzzle burr

Message

papaburger · #1 Post by **papaburger** » Fri Nov 25, 2005 1:30 pm

I was reading the following link

http://www.iowadsl.net/~jpcraig/old/air ... _tips.html

Is muzzle burr bad for accuracy ?

I did the Q-tip test on my IZH-53M pistol and the cotton was pulled ( I cannot hit a beer can at 5 meter with it anyway

, always shot high, big big grouping)

Charles/NM · #2 Post by **Charles/NM** » Sat Nov 26, 2005 12:40 pm

Every gun, air and .22 rimfire, I've removed muzzle burrs from was more accurate afterwards. I have used used are the brass screw with JB Bore Cleaner Paste, pointed Cratex rod and felt Dremel tool with polishing compound. All of those methods worked for me. If the crown is off center or really rough I dress it up in my lathe first then use the above methods to polish it.

airgunfun · #3 Post by **airgunfun** » Sat Nov 26, 2005 1:25 pm

Hell yeah....muzzle burr is a terrible thing for accuracy!!! Follow the advice and clean it up. It's very easy...just take it slow. With a brass screw and some polishing compound ought to do the trick unless there's a terrible nick or gouge and it shouldn't do any harm.

airgunfun · #4 Post by **airgunfun** » Sat Nov 26, 2005 1:39 pm

An article from charliedatuna on deburring muzzles (.doc format).

http://charliedatuna.com/airgun_docs/Ba ... cedure.doc

#5 Post by **sniper** » Sat Nov 26, 2005 1:49 pm

airgunfun wrote:An article from charliedatuna on deburring muzzles (.doc format).

http://charliedatuna.com/airgun_docs/Ba ... cedure.doc

very good article, THX.