barrel making

[airgunnut1]

I haven't been monitering the forum to well for a while now. It is great to see that they have a section for mods. Here is a site you might be interested in that has a really good section on barrel making.

http://www.border-barrels.com/articles/bmart.htm

:::edited by Rob:::: fixed the url

[sniper]

THX for the link.
Very interesting reading, it's totally NOT easy to make a barrel especially a really good one. No wonder there are quite a bit bad ones out there.

Interesting about Pratt & Whitney, I thought they only make airplane engine but rifling machine as well .....wow.....

here is another interesting point:
"Today, barrel hammering machines are built by Gesellschaft Fur Fertigungstechnik und Maschinenbau (GFM) in Steyr, Austria. They cost about a half a million dollars and can spit out a barrel every three minutes."
Very good investment .......

[DoctorFrankengun]

All I get is "Page cannot be found"

[ustilago]

There's an extra [/url] tag in the link. delete the last 5 characters and it should work for you.

Interesting read. . .

[ABshooter]

I haven't been monitering the forum to well for a while now. It is great to see that they have a section for mods. Here is a site you might be interested in that has a really good section on barrel making.

http://www.border-barrels.com/articles/bmart.htm

Well that one worked.

[Jon]

Interesting this, i do not know whether there were any supply problems over the last 16 months but some Russian Steyrs have got Anchutz barrels on, so they say but definately a different diameter.

[Krazy Mike]

That address is not working at all. It says page is not there Or not found...



KM...

[chuck]

[quote="airgunnut1"]I haven't been monitering the forum to well for a while now. It is great to see that they have a section for mods. Here is a site you might be interested in that has a really good section on barrel making.
Maybe this will help Chuck
:::edited by Rob:::: [img] http://www.border-barrels.com