Joint the club with ROB - Airgunfun .......

[sniper]

I thought HW100T was my X-mas present ...no it came too early, and just
like the rest of the other 8 gun after that BUT this one came just in time
for X-MAS .... this is it .... my own X-MAS Present .... yahoooo ....
Just like Rob said this thing can eat co2 and pellets like nothing .....
I load 10 - .22 hobby in the mag. cock it and bam bam bam ....less than
5 second there goes 10 shots, reload 10 and another 10 there goes
the co2 powerlet .......... WOW..... IT IS SO MUCH FUN KNOCKING THOSE
TARGETS.
Very smooth blow back action .... amazing..... THIS IS A MUST HAVE.

[sniper]

[airgunfun]

Welcome to the club!!!! The novelty will soon wear off. Give you $20 for it...

[Tailgunner]

http://cgi.ebay.com/Crosman-600-Seal-Ki ... dZViewItem

I hope this link will work..........might be a handy thing to have.

Merry Chrismas - Gus

[airgunfun]

It's a great idea but DIY repairs on the 600 is not for the faint of heart. Sniper, do you plan to do your own work on the 600 when needed?

[sniper]

Welcome to the club!!!! The novelty will soon wear off. Give you $20 for it...

....lol.... hahaha ... you wish I put it up for sale .... win $ 20 bucks ...

When the novelty does wear off, this baby is going to its original box and
put away for the next another 35 years or so ....

There are all kinds of experiment line up for this baby .... I was thinking
what if instead of CO2 .....HPA....... hmmmm.

[sniper]

Sniper, do you plan to do your own work on the 600 when needed?

Yes, I have a rough idea so far about the blow back on this gun, I've seen
a design almost there on G1200, I have no idea why. The loading system
is pretty much just like the CR99, so it should be a problem ..........

[airgunfun]

OK..OK...22.50 but that's it....

Some internal pics of the CR600 courtesy of supersundance...

http://www.airgunforum.ca/forum/viewtop ... cr600.html

[Parker_101_]

Congratulation there sniper.....that is a cool gun......nice to see the xisico bulk cap fits on it......maybe you want to drop it off down my chimney.......I'll leave the fire place off for the next couple days or so..........

[sniper]

Thanks guys,

This gun is addictive, need more supply of .22 & tons of co2 .....
I should direct feed from the 50 pounder ....lol...

[airgunfun]

WARNING WARNING!!! ACHTUNG ACHTUNG!!!

THE CONTINUED USE OF CROSMAN 600 PISTOLS IS WAY TOO MUCH FUN FOR THE COMMON AIRGUNNER AND THEY COST WAY TOO MUCH TO FEED!!!!

EVERY OWNER IS INSTRUCTED TO SELL THEIR CROSMAN 600 PISTOL(S) IMMEDIATELY TO ROB FOR THE FLAT FEE OF CAD$50.00 EACH.

PLEASE SEND A PM OR E-MAIL FOR INSTRUCTIONS ON HOW TO PACKAGE & SEND THESE HEINOUS AIRGUNS!!!

WARNING WARNING!!! ACHTUNG ACHTUNG!!!

[ABshooter]

LOL

[sniper]

Chrono test on CO2, 5 seconds pershot 392 fps - 375 fps, rapid fire 357 fps. Good for 30 shots.

CO2 bulk fill good for 23 shots.

Now this is very interesting HPA, pump it up with Hill MK2 to 1500 - 1700 PSI,
Easy pumping about 30 seconds, total 17 strokes
chrono show 492 fps, dropping 5-10 fps pershot, good for 10 shots before it hits below 400 fps,
noise level went up like shooting with remington subsonic rimfire.
The best of all accuracy increases like amazingly accurate .....
Also the very best no more expense on co2 .....

[airgunfun]

Wait until you install an extended barrel...

[sniper]

Wait until you install an extended barrel...

YES .... I can hardly wait ..... and extended tube..... with HPA
It should be able to get at least 25 or more shot consistently.
I would figure from 490 - 500 fps for about 25 shots, at about
somewhere 27 strokes of pumping in about less than 1 minute.

I just remember with the extended barrel fps would be alot higher
so for sure it will break the 500 mark.