Poor old airgun.

Message

airsmith282 · #16 Post by **airsmith282** » Mon Dec 26, 2005 11:58 pm

did you take the spring out yet to see if its broken any where...also if you try and jack the gun to much it wont cock properly also the sear may have a problem as well...try using your finger to keep the trigger forward and then cock the gun see what happens .. just a few ideas

350mag1 · #17 Post by **350mag1** » Wed Dec 28, 2005 7:25 am

Besure that there wasn't a barrel release lever on that gun at one time. If I understand you correctly, once you take the pivot bolt out and seperate the barrel from the latch, it works fine-am I right? If there was a barrel release lever on the gun, you should see the area where it was attached to the gun. Take the stock off and look on the left hand side near the breech area. If there was a barrel release lever on it, there will be a threaded hole where the lever attached. If there is such a hole, I think you found the problem-get the lever and mounting fastener. Kevin at K+S airguns will probably have it.

ralphschaap · #18 Post by **ralphschaap** » Wed Dec 28, 2005 9:16 am

is there any name or model # on the back (top) of the barrel? I have almost the same.

It's a chinese rifle from Shanghai Air Guns / Industry Brand. Like Webstien already said: It's probaly an old version of the B2. These old models are most of the time marked with " model 62" (or "Model 61" for the present B1)

you can use the exploded view of an Slavia 625, it's almost the same:
http://www.luchtbuks.net/index.php?act= ... st&id=5631

Jan · #19 Post by **Jan** » Wed Dec 28, 2005 11:32 pm

Hey guys. Actually I said before there were no marking but actually there are. They are barely visible unless you shine a bright light on。

Says

"
先驱数
Pioneer NO G6432
中国做在
MADE IN CHINA
"

Also I am fairly certain there is no barrel release so that is not the problem. The problem is definately just the little pivot thingy, it cocks closed but not open like it sticks out too far to pivot or something.[/i]

airsmith282 · #20 Post by **airsmith282** » Mon Jan 02, 2006 12:45 pm

Pioneer NO G6432 its a China B1 man i got some parts to fix thoes

dankiller44 · #21 Post by **dankiller44** » Mon Jan 09, 2006 12:20 pm

it is a techforce 40D http://www.compasseco.com/shop/products ... r%20Rifles

marin · #22 Post by **marin** » Mon Jan 09, 2006 12:49 pm

In Bulgaria this rifle cost 20 euro - with optics and pellets