QB78T version

[bill177]

Just to start a thread - I have a QB78T which means it is set up for bulk from the factory.

I did place a valve in line with my 9 oz tank - which allows me to turn and turn off the Co2 supply for easy removal of the 9 oz cylinder I use. The cylinder came from WalMart and is filled from my 20# bulk tank.

When I first received the gun I disassembled and cleaned it - then replaced all the seals with a kit from http://charliedatuna.com/co2.htm. His instructions are very good.

I also did some trigger work, however am not done in that department.

Initial chronograph testing showed 700 fps for Beeman .177 FTS (8.30).

Accuracy shows near single hole at 10-meters.

I am currently using a Tasco 6-24 x 44 mildot scope. Not expensive, but works quite well. A good choice for this gun.

[KILLER-B]

Hey Bill SMALL WORLD !!!!

KB

[sniper22]

Just to start a thread - I have a QB78T which means it is set up for bulk from the factory.

Hi Bill,

Do you mind telling us where in Canada we can get on of those QB78T ?

THX

[perrypan]

Me too. I really wanna know that. Did u bring that from US secretly? HeHee...

[bill177]

you can find info about it at:
http://www.compasseco.com/article_tf78T.htm

I bought it from Compasseco. I do not know if they will ship into Canada or not. This is not a "high power" airgun - so there may be hope. You can call them at 1-800-726-1696.

The model I have is Industry Brand - I don't know if Xisco carries/ships that.

I am over the border in NY state - hope I have not caused any confusion.

[sniper22]

I am over the border in NY state - hope I have not caused any confusion.

Ah .... now it's much clearer .......