damn plastic

Message

Darkflare · #1 Post by **Darkflare** » Fri Feb 10, 2006 9:12 pm

Ok, the problem is that I have a 2289 and when adjusting the sites the elevation screw stripped the plastic of the breach, only the first mm or so because if I screw the screw in without the metal bit it still goes in tight... I don't know how the hell it stripped because i wasn't tighting it that hard... yeah anyway, I was wondering if anyone has had this problem and knows how to remedy it? A longer screw would prolly do it. anyone know if i can get one that will fit from home hardware or a store like it?

I also don't have a credit card currently so that would make ordering a part from crosman harder, do they take anything other than credit cards... I could just order a new rear site for when I get my steel breach in a few months... then again I may just get the red dot... it's all about how much it costs. money is limited currently

Thanks,

~Iain

airgunfun · #2 Post by **airgunfun** » Fri Feb 10, 2006 9:15 pm

Just use some good epoxy. Let it dry and rescrew.

ustilago · #3 Post by **ustilago** » Fri Feb 10, 2006 9:35 pm

PM or e-mail me your address, I have at least a couple of those sights around here somewhere.