Be careful using molykote!

Message

#1 Post by **webstien** » Mon Oct 03, 2005 4:31 pm

Just wanted to warn you guys who use molykote.

Be careful when using it!! Wear gloves and eye protection because this stuff isnt good for your skin.

For more information:

http://www.camd.lsu.edu/msds/m/molybden ... ulfide.htm

airsmith282 · #2 Post by **airsmith282** » Wed Oct 05, 2005 10:19 am

also dont use to much of the molykote either other wise you can end of snaping your spring and or other damage to the gun, you dont need alot of this stuff and if you use to much its not going to go well for the gun..

KILLER-B · #3 Post by **KILLER-B** » Wed Oct 05, 2005 10:34 am

So it sounds to me we would be better off just not using it at all, and using something differant.....is this right??

and if so what do you recomend?

KILLER-B

#4 Post by **webstien** » Wed Oct 05, 2005 10:49 am

KILLER-B wrote:So it sounds to me we would be better off just not using it at all, and using something differant.....is this right??

and if so what do you recomend?

KILLER-B

no no, it works very well but.. just be careful. That site may be exagerating quite a bit because, as someone on the yellow forum pointed out, that site says that sodium chloride (SALT) is dangerous.

KILLER-B · #5 Post by **KILLER-B** » Wed Oct 05, 2005 11:10 am

webstien wrote:no no, it works very well but.. just be careful. That site may be exagerating quite a bit because, as someone on the yellow forum pointed out, that site says that sodium chloride (SALT) is dangerous.

Thanks just wanted to make sure.

KILLER-B