C40

[wolfman]

My C40 will not pierce the CO2 cylinder.
and If you do get it pierced it only shoots every other shoot. What parts do I need to replace. (other than the piercing pin which I already replaced)

[airsmith282]

My C40 will not pierce the CO2 cylinder.
and If you do get it pierced it only shoots every other shoot. What parts do I need to replace. (other than the piercing pin which I already replaced)

2-025
106A035
106-035 hammer spring might as well do it
106-015 index finger

[airsmith282]

My C40 will not pierce the CO2 cylinder.
and If you do get it pierced it only shoots every other shoot. What parts do I need to replace. (other than the piercing pin which I already replaced)

2-025
106A035
106-035 hammer spring might as well do it
106-015 index finger

you also might want to check the co2 lever bar they tend to bend form what i have been told which will also make for a poor perice as well and a new end seal as well if youhave replaced the pericing cap wont hurt to do the end seal as well the old one is likely getting hard any how