Hey guys, any one knows where I can get set of o'rings for air cylinder Hatsan AT 44
Thx
o rings
-
Dont tell my wife
- Posts: 588
- Joined: Wed Nov 04, 2009 9:38 am
- Location: Kitchener / Waterloo
Re: o rings
If you know the sizes you can order online from Spaenaur, or if you are close to Kitchener go to the store. I have always had good luck there.
http://www.spaenaur.com/
Jeff.
http://www.spaenaur.com/
Jeff.
Some people are like slinkies, not much good for anything but they put a smile on your face when you push them down the stairs.
Make a fast friend. Adopt a greyhound.
WAGG. Waterloo Area Greyhound Group.
Make a fast friend. Adopt a greyhound.
WAGG. Waterloo Area Greyhound Group.
-
kaptain Jack
- Posts: 244
- Joined: Sun Jun 05, 2011 3:05 pm
Re: o rings
Thx for replying, no I don't know the sizes, but took the tube apart and went to Able o'rings in Toronto, they managed to match them. But after all the trouble it was the gauge that was leaking, so now a trip back to match that one.
Re: o rings
I try and buy Canadian if possible. But when I needed a fairly large order, I sent out a list of what I needed.
Canadian suppliers were 10x or more expensive (if they even replied, some replied weeks later, or not at all).
Pretty easy choice with those numbers. Best thing to do us find your sizes and place an order from the US.
Canadian suppliers were 10x or more expensive (if they even replied, some replied weeks later, or not at all).
Pretty easy choice with those numbers. Best thing to do us find your sizes and place an order from the US.
-
kaptain Jack
- Posts: 244
- Joined: Sun Jun 05, 2011 3:05 pm
Re: o rings
I agree, minimum order at Able O'ring is $10.
On the other note, I think I just got a Hatsan bug!!!.
My BT65 broke, the loading bolt (rear action) got stuck and won't move al the way back, only about an inch. With the probe on the way I cant remove the screw under it and separate the breech.
Any ideas?
On the other note, I think I just got a Hatsan bug!!!.
My BT65 broke, the loading bolt (rear action) got stuck and won't move al the way back, only about an inch. With the probe on the way I cant remove the screw under it and separate the breech.
Any ideas?