how do i get the pin that the pump pivots on in?

Message

simko · #1 Post by **simko** » Mon Nov 07, 2005 9:46 pm

hey guys, im almost done assembling my airgun....

my 1322 i mean

how do i put the pin in that goes thru the front sight hole and the pump tube and the pump arm?

#2 Post by **Voltar1** » Mon Nov 07, 2005 9:52 pm

I use a smooth close fitting 3/16" punch inserted to align everything and then as the pin is driven in the punch gets pushed out into my hand. Locate the split in the pin to the front as there is no 'bearing' required there.
Walter