Almost ready fer huntin...

Message

simko · #1 Post by **simko** » Thu Nov 10, 2005 3:16 pm

well guys my guns almost ready

just gonna add pump silencers, and replace the pump pivot pin

razpizdiay · #2 Post by **razpizdiay** » Thu Nov 10, 2005 5:07 pm

looking good, i think it would look better if you painted the pump grip so it matches the gun. (green as the stock or black)

pump silencer? if i understand correctly, you are just planning to glue a piece of rubber or anything soft to the pump or the gun tube, right?

whats the point of changing the pump pin?

simko · #3 Post by **simko** » Thu Nov 10, 2005 9:25 pm

puimp silencer = fancy name for rubber tube yep

for paint i might leaveit as is, i dont like painting guns too much

the new pump pin on mine drifts out as i pump it a lot, and i want the old style (pin with clip on the end)

im also gonig to see if i can get a nice muzzlebrake made/

#4 Post by **webstien** » Thu Nov 10, 2005 9:26 pm

where you get the pin style with the things to hold it?

RM422 · #5 Post by **RM422** » Thu Nov 10, 2005 9:29 pm

Cool I have got a 1377c too. I added a 1760 barrel and did some valve mods. Now it holds about 30 pumps. I'm now waiting for a 2200 piston. I also put a scope on mine. I should post a pic once it's all finished. Yours looks cools with the chopped barrel. I kept my 1760 barrel the full length cause I kinda like the sniper look. At 50 ft and 20 pumps it is putting a 7.9gr crosman pointy half an inch into a good solid 2x4. That was before I put the 1760 barrel on and it only had the valve mods. I will try again on the weekend. I assume the 1760 barrel should give better results.

simko · #6 Post by **simko** » Thu Nov 10, 2005 9:35 pm

what valve mods did you do? my .22 sure isnt giving that much power...

its a 2250 barrel at 14" so its not chopped.

the pin is ordered from crosman, ill get you the part nmber when ig et the invoice

RM422 · #7 Post by **RM422** » Fri Nov 11, 2005 4:28 pm

I filed down the teflon valve stem head and put in a lighter valve spring I also filled in the bleed hole. I will tell you how it shoots with the 1760 barrel sunday night. If you can get me that part number thanks.

simko · #8 Post by **simko** » Fri Nov 11, 2005 4:51 pm

pin is 760-071

clip is 760-072

RM422 · #9 Post by **RM422** » Sun Nov 13, 2005 9:20 pm

I used my 1377 with the 1760 barrel this weekend. And with the new barrel and power mods at 30 pumps it almost made it through a 2x4 from 20 feet.

RM422 · #10 Post by **RM422** » Sun Nov 13, 2005 9:20 pm

And thanks for the part #s.